Command Reference Guide

SROS Command Line Interface Reference Guide E1 Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 530
E1 INTERFACE CONFIGURATION COMMAND SET
To activate the E1 Interface Configuration , enter the interface e1 command (and specify the E1 port) at
the Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface e1 1/1
Router(config-e1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 923
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
shutdown on page 935
ping <address> on page 931
show running-config on page 933
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through] on page 531
coding [ami | hdb3] on page 532
framing [crc4] on page 533
loop-alarm-detect on page 534
loopback network [line] on page 535
loopback remote v54 on page 536
remote-alarm [rai | ais] on page 537
remote-loopback on page 538
sa4tx-bit [0 | 1] on page 539
show test-pattern on page 540
snmp trap link-status on page 541
tdm-group <group number> timeslots <1-31> speed [56 | 64] on page 542
test-pattern [ones | zeros | clear | insert | p215 | p220 | p511] on page 543
ts16 on page 544