Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 53
configure
Use the configure command to enter the Global Configuration Mode or to configure the system from
memory. See Global Configuration Mode Command Set on page 200 for more information.
Syntax Description
terminal Enter the Global Configuration Mode.
memory Configure the active system with the commands located in the default
configuration file stored in NVRAM.
network Configure the system from a TFTP network host.
overwrite-network Overwrite NVRAM memory from a TFTP network host.
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Usage Examples
The following example enters the Global Configuration Mode from the Enable Command Mode:
>enable
#configure terminal
(config)#