Command Reference Guide

SROS Command Line Interface Reference Guide DSX-1 Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 529
test-pattern [ones | zeros]
Use the test-pattern command to activate the built-in pattern generator and begin sending the specified
test pattern. This pattern generation can be used to verify a data path when used in conjunction with an
active loopback. Use the no form of this command to cease pattern generation.
Syntax Description
ones Generate continous ones
zeros Generate continous zeros
Default Values
No defaults necessary for this command.
Command Modes
(config-t1 1/1)# T1, DSX-1, E1, or G.703 Interface Configuration Mode required.
(config-t1 1/2)#
Usage Examples
The following example activates the pattern generator for a stream of continuous ones:
(config)#interface t1 1/2
(config-t1 1/2)#test-pattern ones