Command Reference Guide

SROS Command Line Interface Reference Guide DSX-1 Interface Configuration Command Set

signaling-mode [message-oriented | none | robbed-bit]

Use the signaling-mode command to configure the signaling type (robbed-bit for voice or clear channel

for data) for the DS0s mapped to the DSX-1 port.

Syntax Description

message-oriented Clear channel signaling on Channel 24 only. Use this signaling type with QSIG

installations.

none Clear channel signaling on all 24 DS0s. Use this signaling type with data-only or

PRI DSX-1 installations.

robbed-bit Robbed bit signaling on all DS0s. Use this signaling type for voice-only DSX-1

applications.

Default Values

By default, the signaling mode is set to robbed-bit.

Command Modes

(config-t1 1/2)# DSX-1 Interface Configuration Mode required

Usage Examples

The following example configures the DSX-1 port for PRI compatibility:

(config)#interface t1 1/2

(config-t1 1/2)#signaling-mode none