Command Reference Guide

SROS Command Line Interface Reference Guide DSX-1 Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 520
DSX-1 INTERFACE CONFIGURATION COMMAND SET
To activate the DSX-1 Interface Configuration , enter the interface t1 command (and specify the DSX-1
port) at the Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface t1 1/2
Router(config-t1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 923
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
shutdown on page 935
All other commands for this command set are described in this section in alphabetical order.
coding [ami | b8zs] on page 521
framing [d4 | esf] on page 522
line-length <value> on page 523
loopback network [line | payload] on page 524
loopback remote line inband on page 525
remote-loopback on page 526
signaling-mode [message-oriented | none | robbed-bit] on page 527
snmp trap link-status on page 528
test-pattern [ones | zeros] on page 529