Command Reference Guide

SROS Command Line Interface Reference Guide T1 Interface Configuration Command Set

T1 INTERFACE CONFIGURATION COMMAND SET

To activate the T1 Interface Configuration , enter the interface t1 command at the Global Configuration

Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

interface t1 1/1

Router(config-t1 1/1)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

clock source [internal | line | through | through t1 <interface id>] on page 505

coding [ami | b8zs] on page 506

fdl [ansi | att | none] on page 507

framing [d4 | esf] on page 508

lbo long <value> on page 509

lbo short <value> on page 510

loopback commands begin on page 511

remote-alarm [rai] on page 514

remote-loopback on page 515

show test-pattern on page 516

snmp trap link-status on page 517

tdm-group <group number> timeslots <1-24> speed [56 | 64] on page 518