Command Reference Guide

SROS Command Line Interface Reference Guide Serial Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 503
snmp trap link-status
Use the snmp trap link-status command to control the SNMP variable to enable (or disable) the interface
to send SNMP traps when there is an interface status change (ifLinkUpDownTrapEnable per RFC 2863).
Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay
interfaces.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet (eth 0/1), VLAN, T1 (t1 1/1), E1 (e1 1/1), DSX-1
(t1 1/2), G.703, serial (ser 1/1), DDS (dds 1/1), virtual Frame Relay (fr 1), virtual
PPP (ppp 1), SHDSL (shdsl 1/1), and loopback interfaces.
Functional Notes
The snmp trap link-status command is used to control the RFC 2863 ifLinkUpDownTrapEnable OID (OID
number 1.3.6.1.2.1.31.1.1.1.14.0).
Usage Examples
The following example disables the link-status trap on the serial interface:
(config)#interface serial 1/1
(config-ser 1/1)#no snmp trap link-status