Command Reference Guide

SROS Command Line Interface Reference Guide Serial Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 494
SERIAL INTERFACE CONFIGURATION COMMAND SET
To activate the Serial Interface Configuration command set, enter the interface serial command at the
Global Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface serial 1/1
Router(config-ser 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 923
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
shutdown on page 935
All other commands for this command set are described in this section in alphabetical order.
et-clock-source <source> on page 495
ignore dcd on page 496
invert etclock on page 497
invert rxclock on page 498
invert txclock on page 499
serial-mode <mode> on page 500
shutdown on page 501
snmp trap on page 502
snmp trap link-status on page 503