Command Reference Guide

SROS Command Line Interface Reference Guide DDS Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 493
snmp trap link-status
Use the snmp trap link-status command to control the SNMP variable that enables (or disables) the
interface to send SNMP traps when there is an interface status change (ifLinkUpDownTrapEnable of RFC
2863). Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the ifLinkUpDownTrapEnable OID is enabled for all supported interfaces except virtual Frame
Relay interfaces.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet (eth 0/1), VLAN, T1 (t1 1/1), E1 (e1 1/1), DSX-1
(t1 1/2), G.703, serial (ser 1/1), DDS (dds 1/1), virtual Frame Relay (fr 1), virtual
PPP (ppp 1), SHDSL (shdsl 1/1), and loopback interfaces.
Functional Notes
The snmp trap link-status command is used to control the RFC 2863 ifLinkUpDownTrapEnable OID (OID
number 1.3.6.1.2.1.31.1.1.1.14.0).
Usage Examples
The following example disables the link-status trap on the DDS interface:
(config)#interface dds 1/1
(config-dds 1/1)#no snmp trap link-status