Command Reference Guide

SROS Command Line Interface Reference Guide DDS Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 491
remote-loopback
Use the remote-loopback command to configure the interface to respond to loopbacks initiated by a
remote unit (or the service provider). Use the no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Values
By default, all interfaces respond to remote loopbacks.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: T1 (t1 1/1) and DDS (dds 1/1)
Usage Examples
The following example enables remote loopbacks on the DDS interface:
(config)#interface dds 1/1
(config-dds 1/1)#remote-loopback