Command Reference Guide

SROS Command Line Interface Reference Guide DDS Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 490
loopback [dte | line | remote]
Use the loopback command to initiate a specified loopback on the interface. Use the no form of this
command to deactivate the loop.
Syntax Description
dte Initiates a loop to connect the transmit and receive path through the unit.
line Initiates a loop of the DDS circuit towards the network by connecting the transmit
path to the receive path.
remote Transmits a DDS loop code over the circuit to the remote unit. In response, the
remote unit should initiate a line loopback.
Default Values
No default values necessary for this command.
Command Modes
(config-dds 1/1)# 56K/64K (DDS) Interface Configuration Mode required
Usage Examples
The following example activates a line loopback on the DDS interface:
(config)#interface dds 1/1
(config-dds 1/1)#loopback line