Command Reference Guide

SROS Command Line Interface Reference Guide DDS Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 486
DDS INTERFACE CONFIGURATION COMMAND SET
To activate the DDS Interface Configuration , enter the interface dds command at the Global
Configuration Mode prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# interface dds 1/1
Router(config-dds 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 923
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
shutdown on page 935
All other commands for this command set are described in this section in alphabetical order.
clock rate <rate> on page 487
clock source <option> on page 488
data-coding scrambled on page 489
loopback [dte | line | remote] on page 490
remote-loopback on page 491
snmp trap on page 492
snmp trap link-status on page 493