Command Reference Guide

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 476
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet, VLAN, DDS (dds 1/1), serial (ser 1/1), virtual
Frame Relay (fr 1), and SHDSL (shdsl 1/1) interfaces.
Usage Examples
The following example enables SNMP capability on the Ethernet interface:
(config)#interface eth 0/1
(config-eth 0/1)#snmp trap