Command Reference Guide

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 465
ip ospf network [broadcast | point-to-point]
Use the ip ospf network command to specify the type of network on this interface.
Syntax Description
broadcast Set the network type for broadcast.
point-to-point Set the network type for point-to-point.
Default Values
By default, Ethernet defaults to broadcast. PPP and Frame Relay default to point-to-point.
Command Modes
(config-interface)# Interface Configuration Mode
Valid interfaces include: Ethernet, virtual PPP interfaces (ppp 1), virtual Frame
Relay sub-interfaces (fr 1.20), and loopback interfaces
Functional Notes
A point-to-point network will not elect designated routers.
Usage Examples
The following example designates a broadcast network type:
(config-eth 0/1)#ip ospf network broadcast