Command Reference Guide

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 436

arp arpa on page 439

bandwidth <value> on page 440

bridge-group <group#> on page 441

crypto map <mapname> on page 442

dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password> on

page 445

encapsulation 802.1q on page 447

Note

Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list

of valid commands. For example:

Router>enable

Password:

Router#config term

Router(config)#int eth 0/1

Router(config-eth 0/1)#?

access-policy - Assign access control policy for this interface

alias - A text name assigned by an SNMP NMS

arp - Set ARP commands

bandwidth - Set bandwidth informational parameter

bridge-group - Assign the current interface to a bridge group

etc....