Command Reference Guide

SROS Command Line Interface Reference Guide Certificate Configuration Command Set

certificate <serial-number>

Use the certificate command to restore a certificate. Use the no form of this command to remove a specific

certificate from the certificate chain.

Syntax Description

<serial-number> Enter the certificate’s serial number (up to 51 characters). This value can be found

for existing certificates by using the show run command.

Default Values

No defaults necessary for this command.

Command Modes

(config-cert-chain)# Certificate Configuration

Functional Notes

The user typically does not enter this command. It is primarily used to restore certificates from

startup-config when the product is powered up.

Usage Examples

The following example removes the certificate with the serial number

73f0bfe5ed8391a54d1214390a36cee7:

(config-cert-chain)#no certificate 73f0bfe5ed8391a54d1214390a36cee7