Command Reference Guide

SROS Command Line Interface Reference Guide Certificate Configuration Command Set

CERTIFICATE CONFIGURATION COMMAND SET

To activate the Certificate Configuration , enter the crypto ca certificate chain command at the Global

Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

crypto ca certificate chain MyProfile

Router(config-cert-chain)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

do on page 928

end on page 929

exit on page 930

All other commands for this command set are described in this section in alphabetical order.

certificate <serial-number> on page 430

certificate ca <serial-number> on page 431

crl on page 432