Command Reference Guide

SROS Command Line Interface Reference Guide Radius Group Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 416
RADIUS GROUP COMMAND SET
To activate the Radius Group , enter the aaa group server command at the Global Configuration Mode
prompt. For example:
Router>
enable
Router# configure terminal
Router(config)# aaa group server radius myServer
Router(config-sg-radius)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
All other commands for this command set are described in this section in alphabetical order.
server [acct-port <port number>| auth-port <port number>] on page 417