Command Reference Guide

SROS Command Line Interface Reference Guide Crypto Map Manual Command Set

CRYPTO MAP MANUAL COMMAND SET

To activate the Crypto Map Manual , enter a valid version of the crypto map ipsec-manual command at

the Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

crypto map Map-Name 10 ipsec-manual

Router(config-crypto-map)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

All other commands for this command set are described in this section in alphabetical order.

antireplay on page 406

ike-policy <policy number> on page 407

match address <listname> on page 408

set peer <address> on page 410

set session-key [inbound | outbound] on page 411

set transform-set <setname> on page 415

Note

ProCurve SROS Documentation CD