Command Reference Guide

SROS Command Line Interface Reference Guide Crypto Map IKE Command Set

CRYPTO MAP IKE COMMAND SET

To activate the Crypto Map IKE , enter a valid version of the crypto map ipsec-ike command at the

Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

crypto map Map-Name 10 ipsec-ike

Router(config-crypto-map)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

All other commands for this command set are described in this section in alphabetical order.

antireplay on page 397

ike-policy <policy number> on page 398

match address <listname> on page 399

set peer <address> on page 401

set pfs [group1 | group2] on page 402

set security-association lifetime [kilobytes | seconds] <value> on page 403

set transform-set <setname1 - setname6> on page 404

Note

ProCurve SROS Documentation CD