Command Reference Guide

SROS Command Line Interface Reference Guide IKE Client Command Set

IKE CLIENT COMMAND SET

To activate the IKE Client , enter the crypto ike client command at the Global Configuration Mode

prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

crypto ike client configuration pool

ConfigPool1

Router(config-ike-client-pool)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

All other commands for this command set are described in this section in alphabetical order.

dns-server <address1> <address2> on page 393

ip-range <start ip> <end ip> on page 394

netbios-name-server <address1> <address2> on page 395

Note

For VPN configuration example scripts, refer to the VPN Configuration Guide located on

the ProCurve SROS Documentation CD provided with your unit.