Command Reference Guide

SROS Command Line Interface Reference Guide IKE Policy Attributes Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 386
IKE POLICY ATTRIBUTES COMMAND SET
To activate the IKE Policy Attributes , enter the attribute command at the IKE Policy prompt. For
example:
Router>
enable
Router# configure terminal
Router(config)# crypto ike policy 1
Router(config-ike)#attribute 10
Router(config-ike-attribute)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
All other commands for this command set are described in this section in alphabetical order.
authentication [dss-sig | pre-share | rsa-sig] on page 387
encryption [aes-xxx-cbc | des | 3des] on page 388
group [1 | 2] on page 389
hash [md5| sha] on page 390
lifetime <seconds> on page 391
Note
For VPN configuration example scripts, refer to the VPN Configuration Guide located on
the ProCurve SROS Documentation CD provided with your unit.