Command Reference Guide

SROS Command Line Interface Reference Guide IKE Policy Command Set

respond [main | aggressive | anymode]

Use the respond command to allow the IKE policy to respond to negotiations by a peer. Use the no form

of this command to allow the policy to only initiate negotiations.

Syntax Description

main Specify to respond to only main mode.

aggressive Specify to respond to only aggressive mode.

anymode Specify to respond to any mode.

Default Values

By default, respond to any mode is enabled.

Command Modes

(config-ike)# IKE Policy Configuration Mode

Functional Notes

By using the

initiate

and

respond

commands, you can configure the IKE policy to initiate and respond, initiate

only, or respond only. It is an error if you have both

initiate

and

respond

disabled.

Usage Examples

The following example configures the router to initiate and respond to IKE negotiations:

(config-ike)#

respond anymode

(config-ike)#

initiate main