Command Reference Guide

SROS Command Line Interface Reference Guide IKE Policy Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 376
client authentication host xauth-type [generic | otp | radius]
Use the client authentication host xauth-type command to allow the user to specify the Xauth
authentication type if a type other than generic is desired.
Syntax Description
generic Generic authentication type
otp OTP authentication type
radius RADIUS authentication type
Default Values
By default, this is set to generic.
Command Modes
(config-ike)# IKE Policy Configuration Mode
Functional Notes
This command is used along with the client authentication host username . See client configuration pool
<poolname>
on page 378 for more information. When acting as an Xauth host, this command allows the user
to specify the Xauth authentication type if a type other than generic is desired.
Usage Examples
The following example sets the Xauth type to radius :
(config-ike)#
client authentication host xauth-type radius