Command Reference Guide

SROS Command Line Interface Reference Guide IKE Policy Command Set

attribute <policynumber>

Use the attribute command to define attributes for the associated IKE policy. Multiple attributes can be

created for a single IKE policy. Once you enter this command, you are in the IKE Policy Attribute . Refer

to IKE Policy Attributes Command Set on page 386 for more information.

Syntax Description

<policynumber> Assign a number (range: 1-65535) to the attribute policy. The number is the

attribute's priority number and specifies the order in which the resulting VPN

proposals get sent to the far-end.

This command takes you to the (config-ike-attribute)# prompt. From here, you

can configure the settings for the attribute as outlined in the section

IKE Policy

Attributes Command Set

on page 386.

Default Values

By default, no attribute is defined.

Command Modes

(config-ike)# IKE Policy Configuration Mode

Functional Notes

Multiple attributes on an IKE policy are ordered by number (with the lowest number representing the highest

priority).

Usage Examples

The following example defines a policy attribute (

) and takes you into the IKE Policy Attributes :

(config-ike)#

attribute 10

(config-ike-attribute)#