Command Reference Guide

SROS Command Line Interface Reference Guide DHCP Pool Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 369
ntp-server <ip address>
Use the ntp-server command to specify the name of the Network Time Protocol (NTP) server published to
the client.
Syntax Description
<ip address> Specifies the IP address of the NTP server.
Default Values
By default, no NTP server is defined.
Command Modes
(config-dhcp)# DHCP Pool
Usage Examples
The following example specifies the IP address of the NTP server:
(config)#ip dhcp-server pool MyPool
(config-dhcp)#ntp-server 192.168.1.1