Command Reference Guide

SROS Command Line Interface Reference Guide DHCP Pool Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 362
hardware-address <hardware-address> <type>
Use the hardware-address command to specify the name of a Dynamic Host Configuration Protocol
(DHCP) client. Use the no form of this command to remove the configured client name.
Default Values
<type> 1 - 10 Mb Ethernet
Command Modes
(config-dhcp)# DHCP Pool
Syntax Description
<hardware-address> Specifies the hardware address (in hexadecimal notation with colon delimiters) of
the preferred router on the client’s subnet (example d2:17:04:91:11:50).
<type> Optional. Specifies the hardware protocol of the DHCP client.
The hardware type field can be entered as follows:
ethernet Specifies standard Ethernet networks.
ieee802 Specifies IEEE 802 standard networks.
<1-21> Enter one of the hardware types listed in RFC 1700.
The valid hardware types are as follows:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
10 Mb Ethernet
Experimental 3 Mb Ethernet
Amateur Radio AX.25
Proteon ProNET Token Ring
Chaos
IEEE 802 Networks
ARCNET
Hyperchannel
Lanstar
Autonet Short Address
LocalTalk
LocalNet (IBM PCNet or SYTEK LocalNet)
Ultra link
SMDS
Frame Relay
Asynchronous Transmission Mode (ATM)
HDLC
Fibre Channel
Asynchronous Transmission Mode (ATM)
Serial Line
Asynchronous Transmission Mode (ATM)