Command Reference Guide

SROS Command Line Interface Reference Guide DHCP Pool Command Set

DHCP POOL COMMAND SET

To activate the DHCP Pool , enter the ip dhcp-server pool command at the Global Configuration Mode

prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

ip dhcp-server pool MyPool

Router(config-dhcp)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

do on page 928

end on page 929

exit on page 930

All other commands for this command set are described in this section in alphabetical order.

client-identifier <identifier> on page 356

client-name <name> on page 358

default-router <address> <secondary> on page 359

domain-name <domain> on page 361

hardware-address <hardware-address> <type> on page 362

host <address> [<subnet mask> or <prefix length>] on page 364

lease <days> <hours> <minutes> on page 365

netbios-name-server <address> <secondary> on page 366

netbios-node-type <type> on page 367

network <address> [<subnet mask> or <prefix length>] on page 368

ntp-server <ip address> on page 369

option <option value> [ascii | hex | ip] <value> on page 370

tftp-server <server> on page 371

timezone-offset <offset> on page 372