Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 353
spanning-tree priority <value>
Use the spanning-tree priority command to set the priority for spanning-tree interfaces. The lower the
priority value, the higher the likelihood the configured spanning-tree interface will be the root for the
bridge group. To return to the default bridge priority value, use the no version of this command.
Syntax Description
<value> Priority value for the bridge interface. Configuring this value to a low number
increases the interface’s chance of being the root. Therefore, the maximum
priority level would be 0. Range: 0-65535.
Default Values
<value> 32768
Command Modes
(config)# Global Configuration Mode required
Usage Examples
The following example sets spanning-tree priority to the maximum level:
(config)#spanning-tree priority 0