Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 337
snmp-server enable traps <trap type>
Use the snmp-server enable traps command to enable all Simple Network Management Protocol
(SNMP) traps available on your system or specified using the <trap type> option. Use multiple
snmp-server enable traps to enable multiple trap types. Use the no form of this command to disable traps
(or the specified traps).
Syntax Description
<trap type> Optional. Specifies the type of notification trap to enable. Leaving this option blank
enables ALL system traps.
snmp Enables a subset of traps specified in RFC 1157
The following traps are supported:
coldStart
warmStart
linkUp
linkDown
authenticationFailure
Default Values
By default, there are no enabled traps.
Command Modes
(config)# Global Configuration Mode required
Usage Examples
The following example enables the SNMP traps:
(config)#snmp-server enable traps snmp