Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set

clear ip igmp group [<group-address> | <interface>]

Use the clear ip igmp group command to clear entries from the Internet Group Management Protocol

(IGMP) tables. If no address or interface is specified, all non-static IGMP groups are cleared with this

command.

Syntax Description

<group-address> Optional.

Specifies the multicast IP address of the multicast group.

<interface> Optional.

Designates the clearing of parameters for a specific interface (in the format

type slot/port

). For example: eth 0/1.

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following example shows output for the show igmp groups command before and after a

clear ip igmp group command is issued. This example clears the IGMP entry that was registered

dynamically by a host. Interfaces that are statically joined are not cleared:

#show ip igmp groups

IGMP Connected Group Membership

Group Address

Interface

Uptime

Expires

Last Reporter

172.0.1.50

Loopback100

01:22:59

00:02:46

172.23.23.1

172.1.1.1

Ethernet0/1

00:00:14

00:02:45

1.1.1.2

172.1.1.1

Loopback100

01:22:59