Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

mac address-table aging-time <aging time>

Use the mac address-table aging-time command to set the length of time dynamic MAC addresses

remain in the switch or bridge forwarding table. Use the no form of this command to reset this length to its

default.

Syntax Description

<aging time> Set an aging time (in seconds) from 10-1000000. Set to 0 to disable the timeout.

Default Values

By default, the aging time is 300 seconds.

Command Modes

(config)# Global Configuration Mode required

Usage Examples

The following example sets the aging time to 10 minutes:

(config)#mac address-table aging-time 600