Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

lldp [minimum-transmit-interval l reinitialization-delay l

transmit-interval l ttl-multiplier] <numeric value>

Use the lldp command to configure global settings that control the way LLDP functions.

Syntax Description

minimum-transmit-interval

Defines the minimum amount of time between transmission of LLDP frames

(in seconds).

reinitialization-delay

Minimum amount of time to delay after LLDP is disabled on a port before

allowing transmission of additional LLDP frames on that port (in seconds).

transmit-interval Defines the delay between LLDP frame transmission attempts during

normal operation (in seconds).

ttl-multiplier Defines the multiplier to be applied to the transmit interval to compute the

time-to-live for data sent in an LLDP frame.

<numeric value> Specifies the interval, delay, or multiplier.

Default Values

By default, minimum-transmit-interval = 2 seconds (valid range: 1 through 8192); reinitialization-delay =

2 seconds (valid range 1 through 10); transmit-interval = 30 seconds (valid range 5 through 32,768); and

ttl-multiplier = 4 (valid range 2 through 10).

Command Modes

(config)# Global Configuration Mode

Functional Notes

Once a device receives data from a neighboring device in an LLDP frame, it will retain that data for a

limited amount of time. This amount of time is called time-to-live, and it is part of the data in the LLDP

frame. The time-to-live transmitted in the LLDP frame is equal to the transmit-interval multiplied by the

ttl-multiplier.