Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 308
line [console | telnet] <line-number> <ending number>
Use the line command to enter the line configuration for the specified console or telnet session. See the
sections Line (Console) Interface Config Command Set on page 876 and Line (Telnet) Interface Config
Command Set on page 887 for information on the subcommands.
Syntax Description
console Specifies the DB-9 (female) CONSOLE port located on the rear panel of the unit. See
the sections
Line (Console) Interface Config Command Set on page 876 for
information on the subcommands found in this.
telnet
Specifies a Telnet session(s) to configure for remote access. See the section Line
(Telnet) Interface Config Command Set
on page 887 for information on the
subcommands found in this.
<line-number> Specifies the starting Telnet or console session to configure for remote access
(valid range for console: 0; valid range for Telnet: 0 to 4).
If configuring a single Telnet session, enter the Telnet session number and leave
the <ending number> field blank.
<ending number> Optional. Specifies the last Telnet session to configure for remote access (valid
range: 0 to 4).
To configure all available Telnet sessions, enter line telnet 0 4.
Default Values
By default, the Secure Router OS line console parameters are configured as follows:
Data Rate: 9600
Data bits: 8
Stop bits:1
Parity Bits:0
No flow control
By default, there are no configured Telnet sessions.
Command Modes
(config)# Global Configuration Mode required