Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 301
ip radius source-interface <interface>
Use the ip radius source-interface command to specify the NAS (network-attached storage) IP address
attribute passed with the RADIUS authentication request packet.
Syntax Description
<interface> Specifies the source interface (in the format type slot/port). Type ip radius
source-interface ? for a complete list of interfaces.
Default Values
By default, no source interface is defined.
Command Modes
(config)# Global Configuration Mode required
Functional Notes
If this value is not defined, the address of the source network interface is used.
Usage Examples (Continued)
The following example configures the Ethernet 0/1 port to be the source interface:
(config)#ip radius source-interface ethernet 0/1