Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

Step 4:

Apply the created access control policy to an interface. To assign an access policy to an interface, enter

the interface configuration mode for the desired interface and enter access policy <policy name>. The

following example assigns access policy MatchAll to the Ethernet 0/1 interface:

(config)#interface ethernet 0/1

(config-eth 0/1)#access-policy MatchAll

Caution

Before applying an access control policy to an interface, verify your Telnet connection will

not be affected by the policy. If a policy is applied to the interface you are connecting

through and it does not allow Telnet traffic, your connection will be lost.