Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

Step 4:

Make the association between the layer 2 endpoint and the physical interface using the bind command.

Supported layer 2 protocols include Frame Relay and point-to-point protocol (PPP). For example, the

following creates a bind (labeled 5) to make an association between the PPP virtual interface (ppp 7) and

the tdm-group configured on interface t1 1/1 (tdm-group 9).

(config)#bind 5 t1 1/1 9 ppp 7

Usage Examples

The following example creates a PPP virtual interface (labeled 1) and enters the PPP Interface

Configuration Mode:

(config)#interface ppp 1

(config-ppp 1)#