Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 244
Step 4:
Make the association between the layer 2 endpoint and the physical interface using the bind command.
Supported layer 2 protocols include Frame Relay, point-to-point protocol (PPP), and HDLC. For example,
the following creates a bind (labeled 5) to make an association between the HDLC virtual interface (hdlc 7)
and the tdm-group configured on interface t1 1/1 (tdm-group 9).
(config)#bind 5 t1 1/1 9 hdlc 7
Usage Examples
The following example creates a HDLC virtual interface (labeled 1) and enters the HDLC Interface
Configuration Mode:
(config)#interface hdlc 1
(config-hdlc 1)#