Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

(config-fr 7)#interface fr 7.22

(config-fr 7.22)#frame-relay interface-dlci 30

(config-fr 7.22)#ip address 193.44.69.1 255.255.255.252

Step 3: (VALID ONLY FOR T1 INTERFACES)

Specify the group of DS0s used for signaling on the T1 interface by creating a tdm-group. Group any

number of aggregate DS0s together to create a data pipe for layer 2 signaling. Also use the tdm-group

command to specify the per-DS0 signaling rate on the interface. For example, the following creates a

tdm-group labeled 9 containing 20 DS0s (each DS0 having a data rate of 56 kbps).

(config)#interface t1 1/1

(config-t1 1/1)#tdm-group 9 timeslots 1-20 speed 56

(config-t1 1/1)#exit

Step 4:

Make the association between the layer 2 endpoint and the physical interface using the bind command.

Supported layer 2 protocols include Frame Relay and point-to-point protocol (PPP). For example, the

following creates a bind (labeled 5) to make an association between the Frame Relay virtual interface (fr 7)

and the tdm-group configured on interface t1 1/1 (tdm-group 9).

(config)#bind 5 t1 1/1 9 fr 7

Usage Examples

The following example creates a Frame Relay virtual interface (labeled 1) and enters the Frame Relay

Interface Configuration Mode:

(config)#interface fr 1

(config-fr 1)#