Command Reference Guide

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 200
GLOBAL CONFIGURATION MODE COMMAND SET
To activate the Global Configuration Mode, enter the configuration command at the Enable security mode
prompt. For example:
Router>
enable
Router# configure terminal
Router(config)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
exit on page 930
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924
description on page 927
do on page 928
end on page 929
exit on page 930
ping <address> on page 931
show running-config on page 933
All other commands for this command set are described in this section in alphabetical order.
aaa commands begin on page 202
banner [exec | login | motd] <character> <message> <character> on page 210
bridge commands begin on page 211boot config [cflash | flash] <filename> [cflash | flash] <backup
file> on page 212
boot system [cflash | flash] <filename> [cflash | flash] [no-backup | <backup filename>] on page 213
enable password [md5] <password> on page 234
event-history on on page 235
event-history priority [error | fatal | info | notice | warning] on page 236
ftp authentication <listname> on page 238
hostname <name> on page 239
interface commands begin on page 240
ip access-list extended <listname> on page 250
line [console | telnet] <line-number> <ending number> on page 308
lldp [minimum-transmit-interval l reinitialization-delay l transmit-interval l ttl-multiplier] <numeric
value> on page 310