Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set

ENABLE MODE COMMAND SET

To activate the Enable Mode, enter the enable command at the Basic Mode prompt. (If an enable password

has been configured, a password prompt will display.) For example:

Router>enable

Password: XXXXXXX

Router#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the section listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

description on page 927

exit on page 930

ping <address> on page 931

show running-config on page 933

All other commands for this command set are described in this section in alphabetical order.

clear commands begin on page 22

clock auto-correct-dst on page 48

clock set <time> <day> <month> <year> on page 50

clock timezone <text> on page 51

configure on page 53

copy <source> <destination> on page 54

copy console <filename> on page 55

copy flash <destination> on page 56

copy <filename> interface <interface> <slot/port> on page 57

copy tftp <destination> on page 58

copy xmodem <destination> on page 59

debug commands begin on page 60

dir on page 98

disable on page 99

erase [<filename> | startup-config] on page 100

events on page 101

logout on page 102

reload [cancel | in <delay>] on page 103

show commands begin on page 104

telnet <address> on page 194