Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 188
show startup-config
Use the show startup-config command to display a text printout of the startup configuration file stored in
NVRAM.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Usage Examples
The following is a sample output of the show startup-config command:
>enable
#show startup-config
!
!
no enable password
!
ip subnet-zero
ip classless
ip routing
!
event-history on
no logging forwarding
logging forwarding priority-level info
no logging email
!
ip policy-timeout tcp all-ports 600
ip policy-timeout udp all-ports 60
ip policy-timeout icmp 60
!
!
!
interface eth 0/1
speed auto
no ip address