Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 187
show spanning-tree <bridgegroup#>
Use the show spanning-tree command to display the status of the spanning-tree protocol.
Syntax Description
<bridgegroup#> Optional. Display spanning-tree for a specific bridge group.
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Usage Examples
The following is an example output using the show spanning-tree command:
>enable
#show spanning-tree
Spanning Tree enabled protocol ieee
Root ID Priority 32768
Address 00:a0:c8:00:88:41
We are the root of the spanning tree
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32768
Address 00:a0:c8:00:88:41
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Interface
-------------------
Role
-------------------
Sts
-------------------
Cost
-----------
Prio.Nbr
-------------
Type
---------------
eth 0/2 Desg FWD 19 128.2 P2p