Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 184
show radius statistics
Use the show radius statistics command to display various statistics from the RADIUS subsystem. These
statistics include number of packets sent, number of invalid responses, number of timeouts, average packet
delay, and maximum packet delay. Statistics are shown for both authentication and accounting packets.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
show running-config interface tunnel <id> verbose
Usage Examples
The following is an example output using the show radius statistics command:
#
show radius statistics
Number of packets sent:
Number of invalid responses:
Number of timeouts:
Average delay:
Maximum delay:
Auth.
3
0
0
2 ms
3 ms
Acct.
0
0
0
0 ms
0 ms