Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 179
show qos map
The show qos map command outputs information about the QoS map. This information differs based on
how a particular map entry is defined.
Variations of this command include the following:
show qos map
show qos map interface <interface ID>
show qos map <map name>
show qos map <map name> <sequence number>
Syntax Description
<map name> Enter the name of a defined QoS map.
<sequence number> Enter one of the map’s defined sequence numbers.
<interface> Specify an interface to display QoS map information for just that interface (e.g.,
frame-relay, ppp, or atm). Enter the show qos map interface ? command for a
complete list of interfaces.
Default Values
No defaults necessary for this command.
Command Modes
# Enable Mode
Usage Example
#show qos map
qos map priority
map entry 10
match IP packets with a precedence value of 6
priority bandwidth: 400 (kilobits/sec) burst: default
packets matched by map: 125520
map entry 20
match ACL icmp
packets matched by map: 99
map entry 30
match RTP packets on even destination ports between 16000 and 17000
packets matched by map: 0
map entry 50
match ACL tcp