Command Reference Guide

SROS Command Line Interface Reference Guide Basic Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 16
show snmp
Use the show snmp command to display the system Simple Network Management Protocol (SNMP)
parameters and current status of SNMP communications.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Command Modes
> or # Basic or Enable Command Mode
Usage Examples
The following is an example output using the show snmp command for a system with SNMP disabled and the
default Chassis and Contact parameters:
>
show snmp
Chassis: Chassis ID
Contact: Customer Service
0 Rx SNMP packets
0 Bad community names
0 Bad community uses
0 Bad versions
0 Silent drops
0 Proxy drops
0 ASN parse errors