Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 152
show ip mroute [<group-address> | <interface>] [summary]
Use the show ip mroute command to display IP multicasting routing table information.
Syntax Description
<group-address> Optional. IP address of a multicast group.
<interface> Optional. Designates the display of parameters for a specific interface (in the format
type slot/port ). For example: eth 0/1.
summary Optional. Displays a single-line summary for each entry in the IP multicast routing
table.
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Usage Examples
The following is sample output from this command:
>enable
#show ip mroute
IP Multicast Routing Table
Timers: Uptime/Expires
(*, 239.2.170.3), 01:03:19/00:00:00
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
fr 1.20, Forward, 01:03:19/00:01:48
(*, 224.1.1.1), 00:00:01/00:02:58, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list: <-- because lo 100 ifc is joined
Loopback100, Forward/Dense, 00:00:01/00:00:00
(*, 17.0.1.50), 00:00:01/00:02:58, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Loopback100, Forward/Dense, 00:00:01/00:00:00