Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set

show ip interfaces [<interface> | brief]

Use the show ip interfaces command to display the status information for all IP interfaces (or a specific

interface).

Syntax Description

<interface> Optional.

Enter a specific interface to view its status information. If no interface is

entered, status information for all interfaces is displayed. Type

show ip interfaces ?

for a complete list of applicable interfaces.

brief Use this optional keyword to display an abbreviated version of interface statistics

for all IP interfaces.

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following is a sample output of the show ip interfaces command:

>enable

#show ip interfaces

eth 0/1 is UP, line protocol is UP

Ip address is 10.10.10.1

Netmask is 255.255.255.0

MTU is 1500

Fastcaching is Enabled

RIP Authentication is Disabled

RIP Tx uses global version value

RIP Rx uses global version value