Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set

show ip igmp groups <group-address>

Use the show ip igmp groups command to display the multicast groups that have been registered by

directly connected receivers using IGMP. If no group-address is specified, all groups are shown with this

command.

Syntax Description

<group-address> Optional.

IP address of a multicast group.

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following is sample output from this command:

>enable

#show ip igmp groups

IGMP Connected Group Membership

Group Address Interface Uptime Expires Last Reporter

172.0.1.50 Loopback100 00:42:57 00:02:50 172.23.23.1

172.1.1.1 Ethernet0/1 00:05:26 00:02:51 1.1.1.2

172.1.1.1 Loopback100 00:42:57 00:02:51 172.23.23.1