Command Reference Guide

SROS Command Line Interface Reference Guide Enable Mode Command Set
5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 136
show interfaces shdsl
Use the show interfaces shdsl command to display configuration parameters and current statistics for the
SHDSL interfaces (or a specified interface).
Variations of this command include the following:
show interfaces shdsl <slot/port>
show interfaces shdsl <slot/port> performance-statistics
show interfaces shdsl <slot/port> performance-statistics total-24-hour
show interfaces shdsl <slot/port> performance-statistics <x-y>
show interfaces shdsl <slot/port> version
Default Values
No default value necessary for this command.
Command Modes
# Enable Command Mode
Syntax Description
performance statistics Optional. Displays the current 15-minute interval, the current 24-hour totals, and
all 96 stored intervals.
performance-statistics
total-24-hour
Optional. Displays the current 24-hour totals and the past seven 24-hour
intervals.
performance-statistics
<x-y>
Shows the current 15-minute interval, the current 24-hour totals, and all intervals
from x through y. This command is basically the same thing as the
performance-statistics command with the added function of allowing you to
specify a particular interval (or range of intervals) to display rather than displaying
all 96.
Note: If you wish to display the 24th interval, enter
show interface shdsl 1/1
performance-statistics 24-24
. Entering show interface shdsl 1/1
performance-statistics 24
results in displaying the 24-hour statistics. Any
number other than 24 (between 1 and 96) results in the correct display of the
selected interval (e.g.,
show interface shdsl 1/1 performance-statistics 4
shows the 4th interval).
version Optional. Displays current version information (e.g., model and list number,
software version, etc.) for the SHDSL interface.